This tiny little servo can rotate approximately 90 degrees in each direction, giving a total of 180 degrees. You can use any servo code, hardware or library to control these servos.
Good for beginners who want to make stuff move without building a motor controller with feedback and gear box, especially since it will fit in small places. Could have many uses in model railway automation.
Comes with a 3 horns and screws.
Works as a suitable replacement for Peco PL-125 servo motors, but will require a bracket model number 217-107.
High quality and high cost performance.
All Nylon Gear.
245mm connector wire.
Large stall torque of 1.6 Kg.
Small size and light weight.
With 3 sets of servo horns and fittings.
Operating Speed (4.8V no load): 0.12sec/60 degrees
Stall torque: 1.2kg / 42.3oz(4.8V);1.6 kg / 56.4oz (6.0V)
Operating voltage: 3.0-7.2V
Temperature range: -30℃~60℃
Dead band width: 7us
Item weight: 9g
Connector wire length: 24.5cm
Package weight: 53g
Contents of Package
1 x SG90 Gear Micro Servo motor
1 x 25cm wire
3 x Servo Horns
3 x Screw