Kit of components that can be used to motorize and drive most makes of turntable kits including the Dapol and Peco kits.
This kit is complete and includes everything required to battery operate a turntable apart from the batteries. It is also possible to swap the batteries for a regulated 6vdc power supply.
Visual alignment with outlet tracks is possible due to the incorporated gear reduction and the slow rotation.
The clearbox motor gearbox combination can be adjusted to rotate between 2.6RPM to 625RPM. Further reduction is obtained by using worm gear and large gear enabling visual alignment of tracks.
No instructions are included but there is lots of information online explaining how to set this type up.
If mounted directly to the underside of the turntable these units can be very noisy.
Our range of red 4mm bore plastic pulleys will also fit this kit.
This kit is very similar to the Expo kit part number 262-11 and also the kit from Frizinghall Models.
1 x 1.5 - 6 volt clearbox motor
1 x 4 AA battery holder (Batteries not included)
1 x 9 volt battery clip to connect motor to batteries
1 x SPDT On Off On miniature toggle switch
5 metres of blue 7/0.2 wire
5 metres of white 7/0.2 wire
1 x worm gear
1 x large 58 tooth 60mm diameter plastic gear
1 x 150mm long 4mm diameter steel shaft
Contents of Package
1 x Large turntable motorising kit.