Colour changing RGB 5mm water clear LED with inbuilt chip which causes the LED to flash red, green and blue individually for several seconds, then slowly mixes and fades the colours in combination to produce a rainbow sequence.
Colour cycles in about 33s before restarting.
Colours change at a frequency of 1.5Hz.
These LEDs DO require a series resistor which is not included, but are available separately. The resistors listed below are the minimum required for safe operation.
If operating from a 9v DC supply use 100R Model Number 228-510 carbon film resistor.
If operating from a 12v DC supply use 150R Model Number 228-507 carbon film resistor.
If operating from a 16v DC supply use 270R Model Number 228-509 carbon film resistor.
Cathode identified by shorter lead.
For more information on wiring our LEDs Click Here
Sold individually so you only buy what you need.