Two DCC bus termination kits which are also known as a DCC snubbers.
Each termination filter kit includes two 2.5w 150R resistor and two 100nF / 0.1uF capacitor which can be soldered across the ends of the bus wires to suppress voltage spikes and assist maintenance of good DCC signal. We also supply two pairs of screw block connectors to allow fitting to both ends of your DCC bus wiring.
These low cost terminator devices can also extend decoder life and improve overall reliability of your layout.
These components require soldering together.
Installation instructions are supplied.
THESE TERMINATION FILTER KITS ARE NOT POLARITY SENSITIVE.
Instruction on how to fit the termination kits can be found here
To see our DCC bus wiring information page please click here
Contents of Package
2 x DCC power bus wire termination filter kit.