DCC Power Bus Wire Starter Kit for Large Layouts

Description

This large DCC power bus starter wiring kit allows a proper electrical power bus to be created for your larger DCC model railway layout. You are required to solder the dropper wires to the track, and the two components of the filter kits together. No further soldering is required below the baseboard.

If you are using any sort of power booster you should use this large DCC bus wiring kit.

Wiring can be run under and above the baseboards.

Instructions are included for connector use and filter kit fitting.

If you would like the wires in other colours, please use the order comments area on the checkout pages when completing your order to let us know which two colours you would like. All wire sizes are available in black, blue, brown, green, grey, orange, pink, purple, red, white, and yellow at no extra cost.

Instruction on how to fit the termination kits and how to use the scotchlok style connectors can be found here.

To see our DCC bus wiring information page please click here.

Kit Contents

a) 10m of black 32/0.2mm cable which is rated to 6amp. This offers an ideal base for your DCC bus. Model Number 211-401
b) 10m of red 32/0.2mm cable which is rated to 6amp. This offers an ideal base for your DCC bus. Model Number 211-409
c) 5m of black 16/0.2mm multi core wire which is rated to 3amp. Model Number 211-201
d) 5m of red 16/0.2mm multi core wire which is rated to 3amp. Model Number 211-209
e) 26 x red cable splices. These allow the dropper wires to be connected to the main power bus without needing to cut in to it and solder or otherwise make joints. These splices are simply fitted over the cable and the connection made by squeezing them with pliers. The joint is strong and fully insulated. Model Number 213-150
f) 20 x 4.8mm plastic P clips to secure the wiring to the underside of the baseboard. Model Number 212-100
g) 2 x DCC termination filter kits. Model Number 218-006
h) 2 pairs x small terminal blocks to allow easy connection of the termination kits to your bus wires
i) 1 pair x large terminal blocks to allow connection of your DCC bus wires to your controller wires.
j) Termination filter instructions.

Contents of Package

1 x Large DCC non solder layout wiring starter kit.