JavaScript seems to be disabled in your browser.

You must have JavaScript enabled in your browser to utilize the functionality of this website. Click here for instructions on enabling javascript in your browser.

  • Basket cart empty
  • In Your Basket

    0 item(s) totalling £0.00
Description
This heavy duty DCC power bus starter wiring kit allows a proper electrical power bus to be created for your large scale DCC model railway layout. You are required to solder the dropper wires to the track, and the two components of the filter kits together. No further soldering is required below the baseboard.

This kit is only really needed on large scale layouts or where a belt and braces approach is required. The wires are heavier and less easy to conceal in the smaller gauges.

Wiring can be run under and above the baseboards.

Instructions are included for connector use and filter kit fitting.

This kit is only available with black and red wires.

Instruction on how to fit the termination kits and how to use the scotchlok style connectors can be found here.

To see our DCC bus wiring information page please click here.
Kit Contents
a) 10m of black 30/0.25 Tri rated cable which is rated to 11amp. This offers an ideal base for your DCC bus. Model Number 211-750
b) 10m of red 30/0.25 Tri rated cable which is rated to 11amp. This offers an ideal base for your DCC bus. Model Number 211-751
c) 5m of black 16/0.2mm multi core wire which is rated to 3amp. Model Number 211-700
d) 5m of red 16/0.2mm multi core wire which is rated to 3amp. Model Number 211-709
e) 26 x red cable splices. These allow the dropper wires to be connected to the main power bus without needing to cut in to it and solder or otherwise make joints. These splices are simply fitted over the cable and the connection made by squeezing them with pliers. The joint is strong and fully insulated. Model Number 213-150
f) 20 x 4.8mm plastic P clips to secure the wiring to the underside of the baseboard. Model Number 212-100
g) 2 x DCC termination filter kits. Model Number 218-006
h) 2 pairs x small terminal blocks to allow easy connection of the termination kits to your bus wires
i) 1 pair x large terminal blocks to allow connection of your DCC bus wires to your controller wires.
j) Termination filter instructions.
Contents of Package
1 x Heavy Duty DCC non solder layout wiring starter kit.
Qty:  
9 Unit(s) in stock for delivery.
IMAGE DISCLAIMER: Please note that the product images shown are for illustration purposes only and may not be an exact representation of the product. Railwayscenics reserves the right to change product images and specifications at any time without notice. Any measurements given are approximate.
You Recently Viewed:See All
DCC Power Bus Wire Starter Kit for Heavy Duty Layouts
Silverline 3 Piece Scratch Brush Set
Quick Order
Manufacturers
Manufacturer Info
Railwayscenics
Share This Product