Colour changing RGB 3mm water clear LED with inbuilt chip which causes the LED to flash red, green and blue individually for several seconds, then slowly mixes and fades the colours in combination to produce a rainbow sequence.
Colour cycles in about 33s before restarting.
Colours change at a frequency of 1.5Hz.
These LEDs DO require a series resistor which is not included, but are available separately. The resistors listed below are the minimum required for safe operation.
If operating from a 9v DC supply use 330R Model Number 228-506 carbon film resistor.
If operating from a 12v DC supply use 470R Model Number 228-508 carbon film resistor.
If operating from a 16v DC supply use 680R Model Number 228-510 carbon film resistor.
Cathode or negative identified by shorter lead.
Sold individually so you only buy what you need.
For more information on using our LEDs please visit our LED help page